Upgrade Details The firmware of the PFE Advanced 10/100 Outputs has been strongly developed recently and especially the new delay parameter for the Terminal function leads to the fact that the memory chip for the non-volatile values, also called EEPROM, is no longer sufficient for older devices. If old devices with installed Terminal function…
Update Details Feature: Hardware checks at power-up (memory check, sensor checks, radio module check, data integrity checks), with corresponding error messages in the display. Feature: The request for the output details of all five outputs in the remote device access from the PFC Advanced and the Composer has been significantly accelerated. When updating PFE Advanced…
Update Details Feature: Hardware checks at power-up (memory check, sensor checks, radio module check, data integrity checks) with corresponding error messages in the display. Feature: The request for the output details of a group of ten outputs in the remote device access from the PFC Advanced and the Composer has been significantly accelerated. Feature: Enable/disable…
Update Details The firmware of the device has been strongly developed in the last months and numerous useful new functions and improvements have been implemented: Feature: Various automatic hardware and configuration checks added with corresponding error messages in the display at power-up (memory check, data integrity checks). Added detection and warning message in case of…
Highlights Slim, high flames with low wind sensitivity and lowest possible fallout Integrated pressure accumulater buffers pressure fluctuations Operation with Isopar L, IPA or Ethanol Three control options: wired DMX, wireless DMX and Galaxis Advanced Radio Module For DMX (radio or cable) there is an input and output at the Pump Station with looping through…
Highlights Up to three Flame Heads can be connected No mains power required, thanks to integrated battery solution with up to 90 h standby time DMX input and output with loop-through of the signal to up all Flame Heads and additional devices Rugged, power coated aluminum housing, protected against rainwater Operation with Isopar L, IPA…
Update Details Improvements regarding the detection of deep discharges and battery saver function. The device turns itself off if heavy loads like confetti shooters are present before a deep discharge is being recorded. Battery saver takes place after 60 seconds whereas deep discharge event is recorded after 80 seconds. Implementation of ‘Save and Recall Event…
Upgrade Details Highly efficient sleep modes are now available for the PFE Advanced 10/100 Outputs and the PFE Advanced Mini 5 Outputs. The devices can be put into sleep mode by radio command and can also be woken up again at any time by radio. In the case of the PFE Advanced 10/100 Outputs, the…
Upgrade Details For a small surcharge, the PFE Advanced 10/100 Outputs is now also available in the ‘Black Edition’ version with black anodized housing. This is very advantageous for applications on stages or in the SFX area. Product Views
Upgrade Details With this upgrade, two microcontrollers in the device are exchanged for a more powerful version with more program memory. This makes the following new features possible: Feature: Hardware checks at power-up (memory check, data integrity checks), with corresponding error messages in the display. Feature: Currently supported memory size is now up to 32…
