G-Flame Redesign The G-Flame has been redesigned. Here are the most important new features: Omission of the mechanical on/off switch and replacement by a magnetic field sensor for the magnetic pen. This prevents malfunctions as no mechanical parts are involved anymore. Battery saver is now supported. Due to the omission of the mechanical on/off switch, it…
PFE Advanced 20 Outputs A new star has been added to the product range and is already shining bright in the galaxy: PFE Advanced 20 Outputs Please follow this link for more details and many pictures: https://www.firing-system.com/project/pfe-advanced-20-outputs These options are available for an extra charge: – Stepping function – Sleep function – Terminal function…
The firing outputs of the PFE Advanced 10 and 20 Outputs can directly drive magnetic valves (also called solenoids). The coil of every magnetic valve is an inductive load. Every inductive load creates a high voltage peak when it is switched off. This is called self-inductance. This voltage peak has the opposite polarity of the…
Update Details Feature: Hardware checks at power-up (memory check, sensor checks, radio module check, data integrity checks), with corresponding error messages in the display. Feature: Enable/disable device via radio command implemented. The devices can now be enabled or disabled at the PFC by a new menu. If a device has been disabled, incoming firing commands…
Upgrade Details The firmware of the PFE Advanced 10/100 Outputs has been strongly developed recently and especially the new delay parameter for the Terminal function leads to the fact that the memory chip for the non-volatile values, also called EEPROM, is no longer sufficient for older devices. If old devices with installed Terminal function…
Update Details Feature: Hardware checks at power-up (memory check, sensor checks, radio module check, data integrity checks), with corresponding error messages in the display. Feature: The request for the output details of all five outputs in the remote device access from the PFC Advanced and the Composer has been significantly accelerated. When updating PFE Advanced…
Update Details Feature: Hardware checks at power-up (memory check, sensor checks, radio module check, data integrity checks) with corresponding error messages in the display. Feature: The request for the output details of a group of ten outputs in the remote device access from the PFC Advanced and the Composer has been significantly accelerated. Feature: Enable/disable…
Update Details The firmware of the device has been strongly developed in the last months and numerous useful new functions and improvements have been implemented: Feature: Various automatic hardware and configuration checks added with corresponding error messages in the display at power-up (memory check, data integrity checks). Added detection and warning message in case of…
Update Details Improvements regarding the detection of deep discharges and battery saver function. The device turns itself off if heavy loads like confetti shooters are present before a deep discharge is being recorded. Battery saver takes place after 60 seconds whereas deep discharge event is recorded after 80 seconds. Implementation of ‘Save and Recall Event…
Upgrade Details Highly efficient sleep modes are now available for the PFE Advanced 10/100 Outputs and the PFE Advanced Mini 5 Outputs. The devices can be put into sleep mode by radio command and can also be woken up again at any time by radio. In the case of the PFE Advanced 10/100 Outputs, the…
